I got the car to give me a code, A0B6, select level interlock signal or value above threshold, could this be my problem why it wont start?

car came with 4 keys, I tried them all, I guess tomorrow Ill look at the possibility of a loose wire connection

Since the car ran for a short while after the rebuild, the only thing that comes to mind is something electrical came loose when you fixed the timing?

Have you tried using a spare key (if you have one) in case the key you are using has lost it's RF ID info...

Sorry, diagnosing remotely is difficult - even harder for electrical issues....

nope no codes, I put the plugs back in and tried it again , and no luck, I disconected the battery cables and put them together for 15 mins and tried again and ...nothing, I have replaced the crank sensor, and nothing, I dont know what the hell it could be, starting to piss me off

Are there any fault codes recorded in the computer?

ok, my 07 mini S now wont start , after I got a intake cam code, I decided to open up the valve cover and see if the cam was off and sure enough it was, I reset the timing and put her back together, she wont even start now, just cranks over and over, I took out the plugs and they were wet, so I hooked them up to the coils and had a friend try to start the car to see if I could see a spark....no spark, I did see the fuel shooting into the cylinders as it was cranking, what could I have done to make this car not fire , as it was running before, just running poorly